Omron CoaXPress STC-LBGP251BCXP124

No.20S062-00
26/55
STC-LBGP251BCXP124 / STC-LCGP251BCXP124 / STC-LBGP251BCXP124-T / STC-LCGP251BCXP-T
Product Specifications and User’s Guide
9 Camera Functions
This chapter describes the camera functions.
9.1 CXP Configuration
This parameter sets the CoaXPress configuration mode.
GenICam Parameters
CxpLink
Configuration
IEnumeration
Type
Sets CXP configuration mode.
CXP12_X4: CXP-12 (12.500Gbps) 4 lane (Default)
CXP6_X4: CXP-6 (6.250Gbps) 4 lane
CXP3_X4: CXP-3 (3.125Gbps) 4 lane
CXP12_X2: CXP-12 (12.500Gbps) 2 lane
CXP6_X2: CXP-6 (6.250Gbps) 2 lane
CXP3_X2: CXP-3 (3.125Gbps) 2 lane
CXP12_X1: CXP-12 (12.500Gbps) 1 lane
CXP6_X1: CXP-6 (6.250Gbps) 1 lane
CXP3_X1: CXP-3 (3.125Gbps) 1 lane
CXP configuration setting when power on camera
CXP configuration setting can be save as “default CXP configuration” in to “UserSet data” to use default
settings of power on camera.
1. Selects CXP configuration mode when power on camera.
2. Selects UserSet (0 to 7) at UserSetSelector.
3. Executes UserSetSave.
4. Selects UserSet (0 to 7), which is selected above “2.” at UserSetDefault.
* The CXP configuration mode does not change when loading saved UserSet data using by “UserSetLoad”.
9.2 Device Indicator Mode
This parameter sets the LED indicator operation mode.
GenICam Parameters
Device
IndicatorMode
IEnumeration
Type
LED indicator operation mode.
Inactive: Off
Active: Indicates communication status (Default)
Error Status: Off while normal operation and indicates system error only.
Boot Status: Off while normal operation and indicates while booting camera
or system error only.