Omron CoaXPress STC-LBGP251BCXP124

No.20S062-00
34/55
STC-LBGP251BCXP124 / STC-LCGP251BCXP124 / STC-LBGP251BCXP124-T / STC-LCGP251BCXP-T
Product Specifications and User’s Guide
9.14 Multi ROI
The maximum eight ROI regions (one horizontal region x eight vertical regions) are configurable.
Each region must not overlap other regions.
Please set each region (Region0 to 7) from top of image to bottom of image and must not overlap other regions.
The width of multi ROI sets at “Width” parameter. Same size of width applies for all regions.
The total height of multi ROI sets at “Height” parameter.
The frame rate can be increase when decreasing total image height (total of MultiHeight). The size of image
width does not affect frame rate.
When selecting Binning or Decimation function, setting value of Width, Height, OffsetX and OffsetY will be half
of full resolution image. (Minimum value and setting steps do not change)
The frame rate does not increase when selecting Binning or Decimation function.
GenICam Parameters
MultiRegionSelector IEnumeration Type Selects the Multi Region of interest to control.
Range: Region 0 to 7
Default: Region 0
MultiRegionMode
[MultiRegionSelector]
IBoolean Type Multi ROI function On / Off selection
Off: Off (Default)
On: On
MultiHeight
[MultiRegionSelector]
IInteger Type Vertical lines of selected region of multi ROI
Range: 4 to 5,120 lines, Default: 4 lines
Setting steps: 2 lines
MultiOffsetX
[MultiRegionSelector]
IInteger Type Horizontal offset of selected region of multi ROI
Range: 0 to 4,864 pixels, Default: 0 pixels
Setting steps: 2 pixels
MultiOffsetY
[MultiRegionSelector]
IInteger Type Vertical offset of selected region of multi ROI
Range: 0 to 5,116 lines, Default: 0 line
Setting steps: 2 lines
*Note.1: (OffsetX + Width) and (OffsetY + Height) should not be smaller than maximum values.
*Note.2: The maximum frame rate will be change depending on setting of OffsetY when using same height
of region.
<Example> Three multiple regions:
OffsetY_0
Height_0
Width OffsetX_0
Region_0
OffsetY_1
Height_1
Width OffsetX_1
Region_1
Width OffsetX_2
Region_2
OffsetY_2
Height_2