No.20S062-00
49/55
STC-LBGP251BCXP124 / STC-LCGP251BCXP124 / STC-LBGP251BCXP124-T / STC-LCGP251BCXP-T
Product Specifications and User’s Guide
Name Description
TestPatternGeneratorSelector Selects wich test pattern generator is controlled by the TestPattern feature.
TestPattern
[TestPatternGeneratorSelector]
Selects the type of test pattern that is generated by the device as image source.
TestPatternInputValue
[TestPatternGeneratorSelector]
Test Pattern Input Value
11.3 AcquisitionControl
Name Description
AcquisitionMode Sets the acquisition mode of the device. It defines mainly the number of frames to
capture during an acquisition and the way the acquisition stops.
AcquisitionStart Starts the Acquisition of the device. The number of frames captured is specified by
AcquisitionMode.
AcquisitionStop Stops the Acquisition of the device at the end of the current Frame. It is mainly used
when AcquisitionMode is Continuous but can be used in any acquisition mode.
AcquisitionFrameRate Controls the acquisition rate (in Hertz) at which the frames are captured.
TriggerSelector Selects the type of trigger to configure.
TriggerMode [TriggerSelector] Controls if the selected trigger is active.
TriggerSoftware [TriggerSelector] Generates an internal trigger. TriggerSource must be set to Software.
TriggerSource [TriggerSelector] Specifies the internal signal or physical input Line to use as the trigger source. The
selected trigger must have its TriggerMode set to On.
TriggerOverlap [TriggerSelector] Specifies the type trigger overlap permitted with the previous frame or line. This defines
when a valid trigger will be accepted (or latched) for a new frame or a new line.
TriggerDelay [TriggerSelector] Specifies the delay in microseconds (us) to apply after the trigger reception before
activating it.
ExposureMode Sets the operation mode of the Exposure (or shutter).
ExposureTimeSelector Selects which exposure time is controlled by the ExposureTime feature. This allows for
independent control over the exposure components.
ExposureTime
[ExposureTimeSelector]
Sets the Exposure time when ExposureMode is Timed and ExposureAuto is Off. This
controls the duration where the photosensitive cells are exposed to light.
To Next Page
Loading...
