No.20S062-00
42/55
STC-LBGP251BCXP124 / STC-LCGP251BCXP124 / STC-LBGP251BCXP124-T / STC-LCGP251BCXP-T
Product Specifications and User’s Guide
10 IO Function
This chapter describes IO functions.
In this chapter, the IO Port places as “Line”. The follow chart details relationship of Line and IO Port.
IO Port
Pin No.
Line number
2 Line3
3 Line2
4 Line1
5 Line0
GenICam Parameters
LineSelector IEnumeration Type
Select Line
LineMode IEnumeration Type
Switch input / output direction for Line that was selected at LineSelector.
Input: set as input, Output: set as output
LineInverter IBoolean Type Switch polarity inversion ON / OFF for Line that was selected at LineSelector.
False: polarity inversion Off (Active-High),
True: polarity inversion On (Active-Low)
LineStatus IBoolean Type Line status (High / Low)
LineSource IEnumeration Type
Set function for Line that was selected at LineSelector
UserOutputSelector
IEnumeration Type
Select UserOutput
UserOutputValue IBoolean Type Switch voltage level of UserOutput that was selected at UserOutputSelector
False: Low voltage level, True: High voltage level
10.1 Input Port Function
This function sets the input on Line Mode, then assigns Line as input.
The following functions can be assigned as input.
10.1.1 Trigger Input
When select “input” assign port at TriggerSource, input signal can be assigned as Trigger.
The input signal can be switched to Active-Low (LineInverter: true) or Active-High (LineInverter: false).
(*) When the Line polarity changing by LineInverter, active polarity of input trigger signal is changed.
10.1.2 LineStatus
This function monitors the signal status on input Line.
The High level (LineStatus: true) or Low level (LineStatus false) status can be seen through software.
To Next Page
Loading...
