No.20S062-00
50/55
STC-LBGP251BCXP124 / STC-LCGP251BCXP124 / STC-LBGP251BCXP124-T / STC-LCGP251BCXP-T
Product Specifications and User’s Guide
11.4 TransportLayerControl
Name Description
PayloadSize Provides the number of bytes transferred for each image or chunk on the stream
channel. This includes any end-of-line, end-of-frame statistics or other stamp data. This
is the total size of data payload for a data block.
CxpLinkConfigurationStatus This feature indicates the current and active link configuration used by the device.
CxpLinkConfigurationPreferred Provides the link configuration that allows the Transmitter device to operate in this
defaut mode.
CxpLinkConfiguration This feature allows specifying the link configuration for the communication between the
Receiver and Transmitter device.
CxpConnectionSelector Selects the CoaXPress physical connection to control.
CxpConnectionTestMode
[CxpConnectionSelector]
Enalbes the test mode for and individual physical connection of the device.
CxpConnectionTestErrorCount
[CxpConnectionSelector]
Reports the current connection error count for test packets received by the device on
the connection selected by CxpConnectionSelector.
CxpSendReceiveSelector Selects which one of the send or receive features to control.
CxpConnectionTestPacketCount
[CxpSendReceiveSelector]
Reports the current count for test packets received by the device on the connection
selected by CxpConnectionSelector.
CxpErrorCounterSelector Selects which Cxp Error Counter to read or reset.
CxpErrorCounterReset
[CxpErrorCounterSelector]
Resets the selected Cxp Error Counter on the connection selected by
CxpConnectionSelector. The counter starts counting events immediately after the reset.
CxpErrorCounterValue
[CxpErrorCounterSelector]
Reads the current value of the selected Cxp Error Counter on the connection selected
by CxpConnectionSelector.
CxpErrorCounterStatus
[CxpErrorCounterSelector]
Returns the current status of the selected Cxp Error Counter on the connection selected
by CxpConnectionSelector.
Image1StreamID Gives the ID for the 1
stream.
11.5 DigitalIOControl
Name Description
LineSelector Selects the physical line (or pin) of the external device connector to configure.
LineMode [LineSelector] Controls if the physical Line is used to Input or Output a signal.
LineInverter [LineSelector] Controls the inversion of the signal of the selected input or output Line.
LineStatus [LineSelector] Returns the current status of the selected input or output Line.
LineSource [LineSelector] Selects which internal acquisition or I/O source signal to output on the selected Line.
LineMode must be Output.
UserOutputSelector Selects which bit of the User Output register will be set by UserOutputValue.
UserOutputValue
[UserOutputSelector]
Sets the value of the bit selected by UserOutputSelector.
StrobeOutDelay Delay of StrobeOut signal when LineSource is set to StrobeOut (us).
StrobeOutOnTime Duration of StrobeOut signal when LineSource is set to StrobeOut (us).
TriggerOutDelay Delay of TriggerOut signal when LineSource is set to TriggerOut (us).
TriggerOutOnTime Duration of TriggerOut signal when LineSource is set to TriggerOut (us).
LineDebounceTime Sets the value of the input line debouncer time.
To Next Page
Loading...
