No.20S062-00
39/55
STC-LBGP251BCXP124 / STC-LCGP251BCXP124 / STC-LBGP251BCXP124-T / STC-LCGP251BCXP-T
Product Specifications and User’s Guide
9.18 Event Control
The camera internal signal can be output as specified event information, like “exposure end”, to PC.
e.g. Event control
GenICam Parameters
EventSelector IEnumeration Type Event notification selection
Exposure Start
Exposure End
Frame Trigger
Frame Start
Frame End
Line 0 Rising Edge
Line 0 Falling Edge
Line 1 Rising Edge
Line 1 Falling Edge
Line 2 Rising Edge
Line 2 Falling Edge
Line 3 Rising Edge
Line 3 Falling Edge
Link Trigger 0
Frame Trigger Missed
Test
Event Notification IEnumeration Type Event notification ON / OFF selection
On: Enable event notification
Off: Disable event notification (Default)
Note: Only Euresys CXP frame grabber board supported Event function (at March 2022)
It is necessary to use StViewer of Sentech SDK v1.1.2_Update6 or later to display Event.
(Viewer from Euresys does not support Event display)
Exposure timing
Frame timing
Event Frame End
Event Frame Start
Event Exposure Start
Event Exposure End
To Next Page
Loading...
