Omron CoaXPress STC-LBGP251BCXP124

No.20S062-00
40/55
STC-LBGP251BCXP124 / STC-LCGP251BCXP124 / STC-LBGP251BCXP124-T / STC-LCGP251BCXP-T
Product Specifications and User’s Guide
9.19 Save and load camera settings
The camera has camera setting save function, camera setting including factory default loads function.
The camera has below two camera settings.
Default: The factory default settings (This setting cannot change)
UserSetX: Over writeable camera settings (X: 0 to 7)
Data type Camera settings FFC data Coordination of defective
pixel
Default Factory default data Factory default data
(FFC is disabled)
Factory default data
UserSet0 to 7 Camera settings for
each UserSet
FFC data for each
UserSet
One common
coordination of defective
pixel data for all UserSet
The camera settings saving and loading is controllable with Parameters (UserSetSelector, UserSetDefault), and
commands (UserSetLoad, UserSetSave) in UserSetControl category of GenICam.
The details of parameters and functions are in table below:
GenICam Parameters
UserSetSelector IEnumeration Type Select “Default” or ”UserSet1”
UserSetLoad or UserSetSave process for selected settings.
UserSetLoad ICommand Type The camera settings load from ROM to register in RAM.
UserSetSave ICommand Type The camera settings at register in RAM save to ROM.
UserSetDefault IEnumeration Type Select which settings (“Default or UserSet X) load automatically when camera
power is on. This selection saves automatically.
9.19.1 Saving the Camera Settings
Setting Procedure
1. Selects “UserSetX” at “UserSetSelector”
2. Execute “UserSetSave”
When UserSetSave is executing,
the camera settings at register in RAM
are saved to ROM that is selected at
UserSetSelector.
Caution:
UserSetSave cannot execute when “Default”
was selected at “UserSetSelector”
ROM
UserSetX
ROM
Default
Camera
Setting
UserSetSelector
Selector