Omron E5CK

CHAPTER 5 PARAMETERS
E5CK
5–22
Ă• The parameters in this mode can be used only when the security" parameter (proĆ
tect mode) is set to 0" to 2".
Ă• This mode contains the auxiliary parameters for adjusting control. These parameĆ
ters include parameters for limiting the manipulated variable, parameters for
switching between remote and local operation, and parameters for setting the LBA
(Loop Break Alarm), alarm hysteresis, and input digital filter values.
Ă• To select this mode, press the
key for 1 second minimum. The display changes
to the menu display. If you select [
] pressing the and keys, and then
press the
key for 1 second minimum, the controller enters the level 2 mode.
Ă• To select parameters in this mode, press the
key. To change parameter settings,
use the
or keys.
Ă• The following table shows the parameters supported in this mode and the page where
the parameter is described.
Symbol
Parameter Name Page
Remote/Local 5-25
Standby time
5-25
LBA detection time
5-26
MV at reset
5-26
MV at PV error
5-27
MV upper limit
5-27
MV lower limit
5-27
MV change rate limit
5-27
Input digital filter
5-28
Alarm 1 hysteresis
5-29
Alarm 2 hysteresis
5-29
Alarm 3 hysteresis
5-29
Input shift upper limit
5-29
Input shift lower limit
5-29
Level 2 Mode