Omron E5CK User Manual

CHAPTER 3 BASIC OPERATION
E5CK
3–2
3.1 Convention Used in this Chapter
This chapter describes basic E5CKĆT operations such as how to set up paĆ
rameters, start and stop operation, and adjust control operation.
For more complex control examples, refer to Chapter 4 Applied Operation
and Chapter 5 Parameters.
The following diagram shows the basic flow of operation.
Power ON
Setup
Setting input specifications
Setting output specifications
Setting alarm output
Protecting parameters
Operation
Start
Adjustment
Stop
Power OFF
Setting patterns
The descriptions in this chapter follow the order of basic operations shown
in the flow above. Examples of operation of each of the items are described
up to completion of parameter setup. However, you must move to the top
parameter of the following Setting. For example, when you have finished
setting input specifications" and you want to set output specifications,"
move to the top parameter of setting output specifications" from the botĆ
tom parameter of setting input specifications."
For details on moving to parameters between items, refer Chapter, SelectĆ
ing modes and Selecting parameters (page 1Ć10).
F Basic Operation
Flow

Omron E5CK Specifications

General

Ambient Operating Temperature	-10 to 55°C
Protection Rating	IP20
Control Type	PID
Input Type	Thermocouple, RTD
Output Type	Relay, Voltage, Current
Power Supply Voltage	100 to 240 VAC
Mounting Type	Panel
Display Type	Digital
Control Output	Relay, Voltage, Current
Alarm Output	Relay
Dimensions	48 x 48 x 78 mm
Ambient Operating Humidity	25% to 85% RH