Omron E5CK

E5CK
5–11
Ă• The parameters in this mode can be used only when the security" parameter (proĆ
tect mode) is set to 0" to 4".
Ă• This mode contains the parameters that you use for programming.
Ă• To select this mode, press the key for 1 second minimum. The display changes
to the menu display. If you select [
] using the and keys, and then press
the
key for 1 second minimum, the controller enters the program mode.
Ă• To select parameters in this mode, press the
key. To change parameter settings,
use the
or keys.
Ă• The following table shows the parameters supported in this mode and the page where
the parameter is described.
Symbol
Parameter Name
Page
Pattern No. 5-7 *1
Number of steps 5-12
Step 0 SP or Target SP 0 5-12
Ramp rate 0 5-13
Step 0 time or Soak time 0 5-13
| |
Step 7 SP or Target SP7 5-12
Ramp rate 7 5-13
Step 7 time or Soak time 7 5-13
Step 8 SP 5-12
Step 8 time 5-13
|
|
Step 15 SP 5-12
Step 15 time 5-13
Pattern execution count 5-14
Alarm value 1 5-14
Alarm value 2 5-14
Alarm value 3 5-14
Time signal 1 enabled step 5-15
Time signal 1 ON time 5-15
Time signal 1 OFF time 5-16
Time signal 2 enabled step 5-15
Time signal 2 ON time 5-15
Time signal 2 OFF time 5-16
*1 This parameter is described as a level 0 mode parameter. For details, see page 5Ć7.
Program Mode