Omron E5CK

CHAPTER 5 PARAMETERS
E5CK
5–10
MV monitor (heat)
MV monitor (cool)
Conditions of Use
The control must be standard control or
heating and cooling control.
Ă• This parameter cannot be set.
Ă• Monitors the manipulated variable on the heating or cooling side.
Ă• The manipulated variable in a standard control system is monitored in the MV monĆ
itor (heat)" parameter.
Ă• The MV monitor (cool)" parameter can be used only during heating and cooling conĆ
trol.
Ă• MV monitor (heat)
Control
Monitor Range
Unit
Standard -5.0 to 105.0 %
Heating and cooling 0.0 to 105.0 %
Ă• MV monitor (cool)
Control
Monitor Range
Unit
Heating and cooling 0.0 to 105.0 %
Level 0 Mode
Function
Monitor