Omron E5CK User Manual

E5CK
5–9
Standby time monitor
Conditions of Use
The controller must be in a standby state.
Ă• Displays the remaining standby time. (This time is not displayed when the controller
is reset.)
Monitor Range
Unit
0.00 to 99.59 Hour, minute
ĂRelated description
4.6 Setting Running Conditions (page 4Ć19)
ĂRelated parameter
Standby time" (level 2 mode)
Pattern elapsing time
Ă• Displays the time that has elapsed since the start of the pattern. When a pattern is
repeatedly executed or all patterns are executed, the time counting restarts at the top
of each pattern.
Monitor Range
Unit
0.00 to 99.59 Program time unit
When the time exceeds 99.59", 99.59" blinks on the display.
Pattern execution count monitor
Ă• Displays the number of times that the current pattern has been executed. 0" is disĆ
played when the controller is reset or when the controller is in a standby state.
Monitor Range
Unit
0 to pattern execution count Times
ĂRelated parameter
Pattern execution count" (program mode)
Level 0 Mode
Function
Monitor
See
Function
Monitor
Function
Monitor
See

Omron E5CK Specifications

General

Ambient Operating Temperature	-10 to 55°C
Protection Rating	IP20
Control Type	PID
Input Type	Thermocouple, RTD
Output Type	Relay, Voltage, Current
Power Supply Voltage	100 to 240 VAC
Mounting Type	Panel
Display Type	Digital
Control Output	Relay, Voltage, Current
Alarm Output	Relay
Dimensions	48 x 48 x 78 mm
Ambient Operating Humidity	25% to 85% RH