CHAPTER 4 APPLIED OPERATION
E5CK
4–18
Ă• There is no order of priority in event input, key operations and commuĆ
nications command setup. However, remote/local, auto/manual, hold/
hold cancel or pattern selection be set to either of ON or OFF. So, paramĆ
eters will always follow event input even if you try to switch settings by
key operation and communications commands.
Ă• Program operation is stopped (reset) at the rising edge (OFF
³ON) of
the event input signal, and the RST LED lights. Program operation is
started (run) at the falling edge (ON
³OFF) of the event input signal.
Ă• When event input is set to ON", the controller is switched to manual
operation, and the MANU" LED lights.
Ă• This function is enabled only during program operation.
Ă• The program is paused (Hold) when the event input is ON, and the
HOLD" LED lights. Holds continue until the state of the event input
changes to OFF.
Ă• This function is enabled only during program operation.
Ă• Program steps are advanced at the rising (OFF³ON) edge of the event
input signal. Accordingly, be sure to set event input OFF before you use
this function.
Ă• This function is enabled only when the program is reset.
Ă• Patterns are selected by pattern select input. The number of patterns
that can be selected are dependent on the value set to the number of patĆ
terns" parameter. For example, when this parameter is set to 4", you
can select from patterns 0 or 2.
Symbol Parameter Name: Mode Description
Event input assignments Option
Event input functions
JDetailed
description of
input functions
F Run/Reset
Reset Run
F Auto/Manual
F Hold/Hold cancel
F Advance
Advance
F Pattern select
Parameters
To Next Page
Loading...
Need help?
General
