7 Offline Debugging
7 - 6
Vision System FH Series Operation Manual for Sysmac Studio (Z343)
For details on how to register to the EtherCAT slave, refer to 5-1 EtherCAT Configuration and
Settings in Sysmac Studio Version 1 Operation Manual (Cat. No. W504-E1-08 or later).
2 Configure the vision sensor settings.
Double-click [NodeX: FH-XXXX]-[Line X]-[Scene data]/[System data] in the Multiview Explorer.
The corresponding data settings screen appears in the Edit Pane. Configure the various settings.
3 Create device variables.
Create device variables to access the FH.
For details on how to create device variables, refer to 4-1-2 Creating Device Variables in Sys-
mac Studio Version 1 Operation Manual (Cat. No. W504-E1-08 or later).
4 Create and build a program to operate the device.
For details on how to create a program, refer to 4-5 Programming in Sysmac Studio Version 1
Operation Manual (Cat. No. W504-E1-08 or later).
5 Open the scene monitor window.
Right-click [FH-XXXX] - [Line X] in the network configuration editing pane and then select [Mon-
itor window].
To Next Page
Loading...
