Precautions for Safe Use
16
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
Precautions for Safe Use
• Please do not use this product to directly or indirectly use to detect the human body for the purpose
of ensuring the safety. In the same application, please use the safety sensor that is published on our
sensor catalog.
• Omron products are designed and manufactured as general-purpose products for use in general
in
dustrial applications. They are not intended to be used in the following critical applications. If you
are using Omron products in the following applications, Omron shall not provide any warranty for
such Omron products, unless otherwise specifically agreed or unless the specific applications are
intended by Omron.
(a) Applications with stringent safety requirements, inc
luding but not limited to nuclear power control
equipment, combustion equipment, aerospace equipment, railway equipment, elevator/lift equip-
ment, amusement park equipment, medical equipment, sa
fety devices and other applications that
could cause danger/harm to people's body and life.
(b) Applications that require high re
liability, including but not limited to supply systems for gas, water
and electricity, etc., 24 hour continuous operating systems, financial settlement systems and other
applications that handle rights and property.
(c) Applications under severe condition or in severe en
vironment, including but not limited to outdoor
equipment, equipment exposed to chemical contamination, equipment exposed to electromagnetic
interference and equipment exposed to vibration and shocks
(d) Applications under conditions and envir
onment not described in specifications
*1. In addition to the applications listed from (a) to (d) above, Omron products (see definition) are not intended for
use in vehicles designed human transport (including two wheel vehicles). Please do NOT use Omron prod-
ucts for vehicles designed human transport. Please conta
ct the Omron sales staff for information on our auto-
motive line of products.
*2. The above is part of the Terms and Conditions Agreement. Please use carefully read the contents of the guar-
antee and disclaimers described in our latest version
of the catalog, data sheets and manuals.
• Do not use the product in areas where flammable or explosive gases are present.
• Install the product so that air can flow freely through its cooling vents.
• Clean the vent hole and discharge opening to preven
t dust or particles from blocking them. Blocked
cooling vents or discharge opening of the fan increasing heat inside, causing malfunction of the prod-
uct.
• Do not install the product close to high-voltage devices and power devices in order to secure the
sa
fety of operation and maintenance.
• Make sure to tighten all inst
allation screws securely.
• When mounting the Sensor Controller using the DIN rail mounting bracket, make sure the screw is
tigh
tened.
• Make sure to mount the DIN rail.
Condition of the fitness of OMRON products
Installation Environment
To Next Page
Loading...
