Precautions for Safe Use
18
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
• Use only the camera and cables designed specifically for the product. Use of other products may
result in malfunction or damage of the product.
• Always turn OFF the power of the Sensor
Controller and peripheral devices before connecting or dis-
connecting a camera or cable. Connecting the cable with po
wer supplied may result in damage of the
camera or peripheral devices.
• For the cable that is flexed repeatedly, use the robotic cable type (Bend resistant camera cable) to
pr
event damages.
• Do not apply torsion stress to the cable. It may damage the cable.
• Secure the minimum bending radius of the ca
ble. Otherwise the cable may be damaged.
• Do not apply stress to the connector by pulling or bendi
ng the cable. It may damage the connector.
• Do not attempt to dismantle, repair, or modify the product.
• Should you notice any abnormalities, imme
diately stop use, turn OFF the power supply, and contact
your OMRON representative.
• While the power is ON or immediately after the powe
r is turned OFF, the Sensor Controller and cam-
era case are still hot. Do no
t touch the case.
• When disposing of the product, treat it as an industrial waste.
• Do not drop the product nor apply excessive vibrati
on or shock to the product. Doing so may cause
malfunction or burning.
• This product is heavy. Be careful not to drop it while handling.
• A lithium battery is incorporated, so
a severe injury may rarely occur due to ignition or explosion.
• Be sure to take fail-safe measures externally w
hen controlling stages and robots by using the mea-
surement results of the Sensor Controller (axis movem
ent output by calibration and alignment mea-
surement).
Other
To Next Page
Loading...
Need help?
General
