F
-
4300 CLAMP
-
ON ULTRASONIC FLOW METER
ONICON Incorporated 727.447.6140 Page 10 onicon.com
SECTION 2.0 UNPACKING
The F-4300 is generally shipped in one package. Notify the freight carrier and ONICON if any items are damaged in
transit.
2.1 CHECKING THAT YOU HAVE RECEIVED EVERYTHING
Documentation
Enclosed with each F-4300 is a comprehensive documentation package that includes the following items:
•
•
•
Please notify ONICON if any of these items are missing.
The Wall Mount Enclosure
Remove the F-4300 enclosure from the shipping carton and inspect it inside and out for physical damage. Please notify
ONICON immediately if you discover any damage.
Inspect the transducers for signs of damage. Each transducer will have a label attached with a serial number associated
with it that can be found on the F-4300 enclosure.
Transducer Cables
BNC Connector for 10 and 20 Series Transducers
is already terminated with a BNC connector for connection to the transducers. The other end is pre-terminated for
connection to the electronics.
Submersible Connection (NEMA 6 - IP67) for 10 Series Transducers
connected to the transducers. The other end is pre-terminated for connection to the electronics.
Threaded Strain Relief Connection (NEMA 4 - IP66) for 30 Series Transducers
threaded strain relief connector for connection to the transducers. The other end is pre-terminated for connection to the
electronics.
Installation Hardware Includes:
• Two (2) mounting brackets
•
• One (1) alignment and spacer tool
• One (1) tube of coupling compound
• One (1) mounting kit that includes:
Pipe straps
Level
IMPORTANT NOTE
The ONICON F-4300 Clamp-on Ultrasonic Flow Meter is a custom calibrated system. Unless specically noted in
writing by ONICON, ALL COMPONENTS must be installed together as a system. Mixing components from dierent
systems will result in signicant errors in measurement.
To Next Page
Loading...
Need help?
General
