F
-
4300 CLAMP
-
ON ULTRASONIC FLOW METER
ONICON Incorporated 727.447.6140 Page 44 onicon.com
Message Display Page
log used, sensor status, and temperatures measured by both the upstream and
downstream transducers.
Status Display Page
programmed in the meter, signal strength, and relay status again.
between 0-100%. 100% indicates that the meter is successfully transmitting
between the upstream and downstream transducers.
should be noted. You will need to check transducer installation, pipe type and
dimensions, and meter programming to resolve these potential issues.
24 Hour Log Display Page
make room for the newest.
4.4 RUN MODE PAGES
Main Display Page
rate if you selected the velocity operating mode in the programming menu.
previous page for their descriptions.
--Messages----------
Data Log Logging
Log Used 0.00000%
Sensor Good
USG/m
Tot 20130 USG
Relays 1 2 3 4 5 6
0.00
--Status------------
Velocity 0.00 ft/s
Flow 0.00 USG/m
Min Flow 4.00 USG/m
Signal Strength 100%
Exp. SOS 4900 ft/s
Meas. SOS 4900 ft/s
--24 hr log----------
Date Mar. 20/2020
Total 50138 USG
Average 34.82 USG/m
Maximum 52.20 USG/m
Max Time 11:08:00
Minimum 0.000 USG/m
Min Time 9:15:00