OpenText Tableau Forensic TX1 Imager
The Information Company 101
log to indicate the date and time of the event. When unexpected power loss is the cause
of the pause, there is no time for the system to log the pause time before shutting down,
so that information is unavailable and thus not included in the log. In that case, a
message is added to the log after the job is resumed to indicate that the missing pause
information is likely due to a power loss event, and the job’s elapsed time is not
calculated, since it cannot be accurately determined. Each subsequent pause (if
manually initiated) and resume event is logged, providing an accurate capture of how
many pause/resume cycles occurred during the job. The following log sample shows a
completed power loss paused/resumed job. Note that, had this been a manually
paused/resumed job, the line with the possible power loss warning would be replaced by
a Paused field, with the date and time of the pause event.
TX1 als
o allows the resumption of imaging jobs that failed for the following reasons:
• Source drive missing or disconnected
• Destination drive missing or disconnected
• Destination drive full
These types of failed jobs can be resumed through either the Recent jobs area in the
Jobs tab or the job’s log details screen, as described in the sections above. The best
way to tell if a job is resumable or not is to check for the ability to resume it from the
Recent jobs list or in the log details screen.
Copyright © 2022 Open Text. All rights reserved. Trademarks owned by Open Text.
To Next Page
Loading...