OTE PUMA T2 - Fig. D.3: Battery Identification Code

PUMA T2
Technical Handbook
NiCd, NiMH and Li-ion batteries
P/N: 779-0306/01
Revision 03
OTE Proprietary information
Page 119
On the rear side of the battery a small hole can be found. The hole permits out-
gassing during the charging phase. An osmotic protection prevent the battery from
water infiltration.
An electronic circuit protects the battery from :
• Maximum Charging current overload;
• Maximum Discharging current overload;
• Maximum Charging voltage overload;
• Minimum Voltage during discharge.
On the radio side the following information
• Note A (symbols + e -)
• Note B (safety information)
• Note C (identification code area)
In Fig. D.3 the identification code is shown. The code gives the exact date of
production, battery type and capacity (i.e. #021112L7 means 21 th week of 2001,
Li 2700 mAh). The symbol # gives details on the battery package.
Fig. D.3: Battery identification code