PUMA T2
Technical Handbook
Setting Up
P/N: 779-0306/01
Revision 03
OTE Proprietary information
Page 55
4.3 GENERAL DESCRIPTION
The PRP is mainly composed of:
1. an application, resident on the PC, able to manage and carry out the complete
configuration of a set of radios;
2. a communication protocol to transfer the information from the PC to the radio
terminals;
3. a Boot software to be installed on the equipment to enable communication
with the PC.
The main functions, allowed by the MMI of the PRP, are the following:
• downloading of the Boot software into the radio terminal;
• downloading of the code of the equipment;
• downloading of the firmware of the equipment;
• downloading of the equipment data configuration;
• uploading the configuration of the data contained in the database of the radio
terminal and, consequently:
• displaying the uploaded data;
• saving the uploaded data of the PC database;
• comparing the uploaded data from the radio terminal database and the data
stored in the PC database.
Therefore the MMI provides the interface for managing the database and the
users.
To Next Page
Loading...