Panasonic AJ-PX5000G - Page 156

– 156 –
Chapter 7 Menu Operations — Menu list
[KNEE/LEVEL]
Item Description of settings
[MASTER PED] Sets the master pedestal.
[−200]…[200]
f Factory setting: [16]
[[S] MANUAL KNEE] Sets the mode when the <OUTPUT>/<AUTO KNEE> switch is <OFF>. This enables the [KNEE MASTER
POINT]/[KNEE MASTER SLOPE] setting value when the switch is [ON].
[ON], [OFF]
f Factory setting: [ON]
[KNEE MASTER POINT] Sets the knee point position in 0.5% steps.
[70.0%]…[107.0%]
f Factory setting: [93.0%]
The setting becomes invalid when [FILM-REC] or [VIDEO-REC] is selected in the main menu → [PAINT]
→ [GAMMA] → [GAMMA MODE SEL].
[KNEE MASTER SLOPE] Sets the knee inclination.
[0]…[99]
f Factory setting: [85]
The setting becomes invalid when [FILM-REC] or [VIDEO-REC] is selected in the main menu → [PAINT]
→ [GAMMA] → [GAMMA MODE SEL].
[[S] WHITE CLIP] Turns the white clip function [ON]/[OFF]. This enables the [WHITE CLIP LVL] setting value when the
function is [ON].
[ON], [OFF]
f Factory setting: [ON]
[WHITE CLIP LVL] Sets the white clip level.
[90%]…[109%]
f Factory setting: [109%]
[A.KNEE POINT] Sets the auto knee point position in 1% steps.
This is enabled when the <OUTPUT>/<AUTO KNEE> switch is <CAM>/<ON>.
[80%]…[107%]
f Factory setting: [90%]
[A.KNEE LVL] Sets the auto knee level.
[100]…[109]
f Factory setting: [107]
[A.KNEE RESPONSE] Sets the auto knee response speed. The smaller the setting value, the faster the response speed is.
[1]…[8]
f Factory setting: [4]
[CHROMA LEVEL] Sets the chroma level of P
R
and P
B
signals.
When this is set to [OFF], the color components of the video signal are removed.
[OFF], [−99%]…[40%]
f Factory setting: [0%]
[DRS MODE] Sets the effectiveness of DRS color preservation.
[MODE1]: Sets the hue of high-brightness areas to its natural state.
[MODE2]: Makes the hue of high-brightness areas more vivid.
f Factory setting: [MODE1]
[DRS EFFECT DEPTH] Sets the compression level for the high-brightness areas of DRS. The higher the value, the higher the
compression level of high-brightness areas becomes.
[1], [2], [3]
f Factory setting: [1]
[[S] HI-COLOR SW] Turns the mode that expands the color dynamic range [ON]/[OFF].
[ON], [OFF]
f Factory setting: [ON]
[HI-COLOR LVL] Selects the level of the mode that expands the color dynamic range.
[1]…[32]
f Factory setting: [32]
@@
NOTE
t When saving or reading setup les from an SD memory card, you can save items with an [S] and items without an [S] separately. Items with an [S] in
front of the item name are the targets for [PAINT([S]SELECT)] in the main menu → [FILE] → [SETUP DATA SELECT]. Items without an [S] are targets
for [PAINT(LEVEL)].