Panasonic AJ-PX5000G - Sdi Out1 Marker

– 177 –
Chapter 7 Menu Operations — Menu list
Item Description of settings
[SDI EDH] Sets whether to add an error detection ag to SD SDI output.
[ON], [OFF]
f Factory setting: [ON]
[HDSDI REMOTE] Sets whether to use the control function of recording operation for an external device (such as a recorder)
connected to the <SDI OUT1> terminal or <SDI OUT2> terminal. (At HD SDI output)
[ON], [OFF]
f Factory setting: [OFF]
Selecting [ON] outputs recording operation control to an external device. While recording is instructed, the
red tally lamp, front tally lamp, back tally lamp of the viewnder of the camera, and the rear tally lamp of
the camera illuminate. The display method for the recording status of the camera can be selected from the
main menu → [REC/PB] → [REC/PB SETUP] → [REC TALLY].
Recording operation control is not output in interval recording, one-shot recording, and loop recording.
Recording operation control is not output when 4G/LTE is set.
For the information on the supported external devices (such as recorders), visit the following website:
http://panasonic.biz/sav/autorec_e/
[THUMBNAIL OUT] Selects whether to output the thumbnail of a clip displayed on the LCD monitor to the <SDI OUT1>
terminal, <SDI OUT2> terminal, <HDMI OUT> terminal, and <VIDEO OUT> terminal.
[ON]: Performs output.
[OFF]: Does not output.
f Factory setting: [OFF]
[SDI OUT1 MARKER]
Item Description of settings
[MARKER SW] Switches the marker.
[ON]: Displays.
[OFF]: Does not display.
f Factory setting: [OFF]
[CENTER MARK] Switches the center marker.
[1]:+(large)
[2]: Open center (large)
[3]:+(small)
[4]: Open center (small)
[OFF]: Does not display.
f Factory setting: [1]
[SAFETY MARK] Selects the type of frame for the safety zone marker.
[1]: Box
[2]: Corners
[OFF]: Does not display.
f Factory setting: [2]
[SAFETY AREA] Sets the size of the safety zone marker.
The constant ratio of length to width can be set in 1% increments.
[80%]…[100%]
f Factory setting: [90%]
[FRAME MARK] Enables/disables frame marker.
[ON], [OFF]
f Factory setting: [OFF]
[FRAME SIG] Sets frame marker aspect ratio.
[4:3], [13:9], [14:9], [VISTA], [CNSCO]
f Factory setting: [4:3]
[VISTA] is 16:8.65, and [CNSCO] is 16:6.81.
[USER BOX] Sets whether to display the user box to the signal from the <SDI OUT1> terminal.
[ON], [OFF]
f Factory setting: [OFF]
[USER BOX WIDTH] Sets the width of the user box.
[1]…[100]
f Factory setting: [13]
[USER BOX HEIGHT] Sets the height of the user box.
[1]…[100]
f Factory setting: [13]
[USER BOX H POS] Sets the horizontal position of the center of the user box.
[−50]…[50]
f Factory setting: [0]
[USER BOX V POS] Sets the vertical position of the center of the user box.
[−50]…[50]
f Factory setting: [0]
[MONI OUT MARKER]