Panasonic AJ-PX5000G - Displaying the Upload List

– 238 –
Chapter 9 Network Connection — Rec during upload function
You can check the transfer status of clips registered in the upload list in the main menu → [I/F SETUP] → [USB/LAN] → [FTP CLIENT SERVICE] →
[UPLOAD LIST].
The viewnder or LCD monitor shows the operation status of the rec during upload function. In addition, the thumbnail screen shows the operation
status of the rec during upload function and the transfer status of clips.
@@
NOTE
t The clips selected with the manual selection mode will be transferred prioritized to the clips registered to the upload list with the automatic transfer
mode.
t Upload of the clip will start after the rec during upload is set to enable. To prevent the upload error, do not remove the card from the P2 memory card
slot and the microP2 memory card slot.
t Up to 100 clips can be registered in the upload list for the upload of clips. Clips exceeding 100, excluding the uploaded clips and clips failed to upload
cannot be registered.
t Clips are also automatically transferred during recording, playback, and thumbnail display.
t If the network is disconnected during transfer, or the power of the camera is turned off and on again, transfer resumes in clip units.
t While the rec during upload function is enabled, the last clip delete function is disabled.
t While the rec during upload function is enabled, the streaming function is disabled.
t The directory on the FTP server is not listed in the FTP explorer screen during the transmission or waiting to transmit the clips registered in the upload
list.
t While the rec during upload function is enabled, the setting values in the main menu → [I/F SETUP] → [USB/LAN] cannot be changed or initialized.
t The copying between the P2 cards will not operate during the transmission or waiting to transmit the clips registered in the upload list.
t The clip delete function will not operate during the transmission or waiting to transmit the clips registered in the upload list.
t The format function of the P2 card will not operate during the transmission or waiting to transmit the clips registered in the upload list.
Displaying the upload list
The upload list allows you to check the transfer status of clips to be uploaded.
1
Select the main menu → [I/F SETUP] → [USB/LAN] → [FTP CLIENT SERVICE] → [UPLOAD LIST].
The upload list is displayed.
Upload list screen
1 2 3 4
1 [CLIP NAME]
Displays clip names. For the clip where automatic transfer is set, [AUTO] is displayed after the clip name.
2 [STATUS]
Displays the upload status.
[OK]: Uploaded
[ERROR]: Upload failed
[PAUSE]: Preparing the upload
[COPY]: Uploading
[WAIT]: Waiting for upload
3 [SIZE]
Displays the le size.
4 [LAST UPDATE]
Displays the date and time [STATUS] display changed.
Operations on the upload list screen
You can delete, cancel, or re-transfer items from the upload list.
1
Select an item in the upload list using the jog dial button (or the cursor buttons `/{) and press the <SET> button.
2
Perform one of the following operations.
f To delete an item, select [DELETE] using the jog dial button (or the cursor buttons `/{).
f To cancel the upload, select [CANCEL] using the jog dial button (or the cursor buttons `/{).
f To re-transfer an item, select [RETRY] using the jog dial button (or the cursor buttons `/{).
f To delete all items, press the <SHIFT> button and the <RESET> button simultaneously. A conrmation screen is displayed, so select [YES] with the
jog dial button (or `/{). The current log of the clip information registered to the upload list will also be deleted at this time.
f To delete the history (items of which [STATUS] is [OK] or [ERROR]), press the <SHIFT> button and <EXIT> button at the same time. A conrmation
screen will be displayed. Select [YES] using the jog dial button (or the cursor buttons `/{).