115
Wireless LAN
3 Click [On] for [Switch radio].
4 Click [Networks] and click [Add].
5 Enter the profile name and network name (SSID), and make other
necessary changes; then click [Next].
6 Make necessary changes and click [Finish].
z For security, we recommend that you enable encryption (WEP). If you enable
WEP, enable encryption on the access point side as well. (The setting described
below is only an example. For the other settings, ask your system administrator
or the person in charge of the network)
A Select [64-bit] or [128-bit] from [Encryption Level].
B Select [Use pass phrase] or [Use hex key], and input the pass phrase or key.
In the case of ASCII character: [64-bit (5 characters)] [128-bit (13 characters)].
In the case of hexadecimal: [64-bit (10 digits)] [128-bit (26 digits)].
• Set the same values for the computer side and the access point side
• When using an access point for which "128-bit" can be set (some access
points display "104-bit"), we recommend setting data encryption to "128-
bit" to prevent unauthorized decryption
7 Select the profile you have set and click [Connect].
z If the setting of the profile that is currently connected is changed, the new setting
will not be enabled until you select the profile and then click [Connect]
8 Click [OK].
To Next Page
Loading...
Need help?
General