Panasonic DP-3510

148
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
QUANTUM Control Timing
QUANTUM works in Copy, Print or Fax mode.
No Trigger
1 When F8-09 is performed After performing F8-09
Wait approximately 
30 - 90 sec for the 
QUANTUM to start *1
2 At 200, 400, 600, 800 and 1000 prints after F8-09 was
performed
Upon reaching the specified 
number of prints *2
3 Every 1000 prints from 1001 prints after F8-09 was 
performed
Upon reaching the specified 
number of prints *2
4 When the F6-28 value is changed Upon returning to F6 initial display
5 When the F6-29 value is changed Upon returning to F6 initial display
6 When the F6-39 value is changed Upon returning to F6 initial display
7 When the F6-52 value is changed Upon returning to F6 initial display
8 When the Power Switch is turned ON After the Power Switch is turned 
On
9 At 100 prints after the Power Switch was turned ON Upon reaching the specified 
number of prints *2
10 When the Auto Off mode is cancelled After cancelling the Auto off mode
11 At 100 prints after the Auto Off mode was cancelled When reaching the counters *2
12 6 hours after the previous QUANTUM After reaching the specified 
number of prints
13 At 100 prints after the 6 hours lapse from the previous 
QUANTUM
Upon reaching the specified 
number of prints *2
14 At 100 prints after canceling U13 Upon reaching the specified 
number of prints *2
15 When F8-14 is performed After F8-14 is performed
<Note>
*1) Start timing of QUANTUM:
- QUANTUM starts when the machine is ready (It will not work during copy/print/fax operation)
- The start of QUANTUM may change depending on machine status
*2) Any print value numbers shown above, refers to the Total Counter
QUANTUM Start Timing