Panasonic DP-3510

403
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
8.31. Installing the Punch Unit (DA-SP41)
8.31.1. Contents
Note:
1. The part number may differ depending on the Destination.
2. Refer to the Parts List in the Parts Manual.
8.31.2. Installation
CAUTION!
Turn the Power Switch on the Left Side and the Main Power Switch on the Back of the
machine to the OFF position, and then unplug the AC Power Cord before beginning
installation.
Qty. Description Part No. Remarks
1 Punch Unit See Note
1 Punch Relay Harness (Orange) YA1020K374B
1 Punch Relay Harness (Violet) YA1020K375A
1 Jam Removal Label YA1020P828A
1 Punch Dust Label YA1020P208A
1 Screw (M4 x 6) See Note
1 Installation Instructions DZSM000572 This document
1. Removing the Packing Material
Note:
This machine is protected with packing material
such as tape and spacers against vibration and
shocks caused during transportation. Be sure to
remove them before using the machine.
(1) Take the Punch Unit and accessories out of the
package.
(2) Remove the tape securing the Covers and Front
Door.
2. Making Preparations for Installing the Finisher
Side
(1) Turn off the Host Machine and disconnect the
Interface Cable of the Finisher from the Host
Machine.
(2) Release the Latch of the Finisher, and move the
Finisher outward from the host machine.
(3) Open the Front Door. Holding the tab with your
fingers, remove the Jam Clear Dial.
(4) Remove the 2 Screws.
Screw
Screw
Jam
Release
Dial
Tab
Front Door