Panasonic DP-3510

388
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
8.29. Installing the 2 Bin Finisher (DA-FS330)
8.29.1. Contents
Note:
1. The part number may differ depending on the Destination.
2. Refer to the Parts List in the Parts Manual.
3. Before you begin the installation of your 2 Bin Finisher (DA-FS330), read these entire
instructions.
8.29.2. Installation
CAUTION!
Turn the Power Switch on the Left Side and the Main Power Switch on the Back of the
machine to the OFF position, and then unplug the AC Power Cord before beginning
installation.
Qty. Description Part No. Remarks
1 2 Bin Finisher See Note
1 Upper Tray GP01-3415
Assembled
1 Guide Bar GH03-3103
1 Lower Tray GP01-3403
1 Stand DZJA001230
1 Front Cover DZJE001064
1 Rear Cover DZJE001065
1 Front Magnet Catch Plate DZJA001226
1 Rear Magnet Catch Plate DZJA001227
1 Switch Bracket DZJA001225
1 Locking Clamp GS01-6503
1
Exit Roller U Assembly DZHP007718
Except for USA and
Canada
2 Screw (M4 x 8) See Note
2 Screw (M4 x 10) See Note
2 Screw (M4 x 30) See Note
6 Screw (M3 x 10) See Note
1 Installation Instructions DZSM000570 This document
1. Selecting the Installation Site
Make sure that there will be adequate space for the
work (i.e. removal of paper, etc.).
Make sure also that the Finisher will be placed on the
same floor surface as its host machine
(i.e. at the same height, slope, etc.).
63.0 in
(1600 mm)
3.9 in
(100 mm)
3.9 in
(100 mm)
3.9 in
(100 mm)
3.9 in
(100 mm)
57.6 in
(1463 mm)