Panasonic DP-3510

394
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
8.30. Installing the 1 Bin Saddle-Stitch Finisher (DA-FS355A)
8.30.1. Contents
Note:
1. The part number may differ depending on the Destination.
2. Refer to the Parts List in the Parts Manual.
3. Before you begin the installation of your 1 Bin Saddle-Stitch Finisher (DA-FS355A), read
these entire instructions.
8.30.2. Installation
CAUTION!
Turn the Power Switch on the Left Side and the Main Power Switch on the Back of the
machine to the OFF position, and then unplug the AC Power Cord before beginning
installation.
Qty. Description Part No. Remarks
1 1 Bin Saddle-Stitch Finisher See Note
1 Stapler PF4117K226A
1 Delivery Tray PF4117K225A
1 Stand PF4117K604A
1
Exit Roller U Assembly DZHP007718
Except for USA and
Canada
1 Exit Roller Gear 1 (White) FFPMF1069
Except for USA and
Canada
Used for DP-45xx
1 E-Ring See Note
1 Latch Plate PF4117K101A
6 Screw (M4 x 7) See Note
4 Silver Screw (M3 x 10) See Note
2 Silver Screw (M4 x 30) See Note
1 IPC PC Board PF4117P003
2 Spacer PF4117K254 Used for DP-45xx
1 Label DZNK004315
1 Installation Instructions DZSM000759 This document
1. Selecting the Installation Site
Make sure that there will be adequate space for the
work (i.e. removal of paper, etc.).
Make sure also that the Finisher will be placed on the
same floor surface as its host machine
(i.e. at the same height, slope, etc.).
74.2 in
(1885 mm)
3.9 in
(100 mm)
3.9 in
(100 mm)
3.9 in
(100 mm)
3.9 in
(100 mm)
57.6 in
(1463 mm)