308
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
8.7. Installing the Printer Controller Module for PCL6 (DA-PC600)
8.7.1. Contents
Note:
1. The part number may differ depending on the Destination.
2. Refer to the Parts List in the Parts Manual.
8.7.2. Installation
1. Before installing this option, make sure the Program Expansion Board (DA-EM600) is installed
into Slot 1 on the SC PC Board first. Refer to the Installation Instruction of the Program
Expansion Board (DA-EM600).
2. Install the Hardware Key by following the steps below.
CAUTION!
Turn the Power Switch on the Left Side and the Main Power Switch on the Back of the
machine to the OFF position, and then unplug the AC Power Cord before beginning
installation.
Qty. Description Part No. Remarks
1 Hardware Key ----- PCL KEY
1
Software CD
DZRQ000059 or
Includes Operating Instructions
DZRQ000062
1
License Agreement
DZSH000112 For USA and Canada only
1 DZSH000113 For Other Destinations
1 Installation Instructions DZSM000508 This document
(1) Loosen 5 Screws.
(2) Remove the Rear Plate as illustrated.
(1)
(1)
(2)
Main
Powe
SW
To Next Page
Loading...
