Panasonic DP-3510

129
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
Note:
1. Clean all Rollers and Separation Rubber with a soft cloth saturated with water.
For stubborn toner accumulation, wipe with a soft cloth saturated with Isopropyl Alcohol first, then
follow up with a soft cloth saturated with water.
2. The Maintenance Cycle is based on the Counter Information for each individual module.
To verify the counter information, print the Total Counter List using the Service Mode: F7 - Electronic
counter - 00 (List print).
3. Cleaning, Replacement and Adjustment Cycle (Sheet) are based on using Panasonic's recommended
standard paper and supplies. These cycles may vary with the kind of paper used and/or ambient
conditions.
4. The value is determined under the following test conditions. Four continuous prints per job using 6%
image coverage of LT/A4 size.
5. 240K or 1 year whichever occurs first.
3.5. Resetting the P/M (Preventive Maintenance) Counter
When the machine reaches the preset P/M Cycle, it will show “Call for P/M” or “Replace The Toner Waste
Container” on the LCD Display. The PM Counter can be reset by following the procedures below.
3.5.1. “Call for P/M” (Default: 120K (DP-35xx/45xx), 240K (DP-60xx))
1. Perform the P/M (Preventive Maintenance). Refer to Section 3.3 and 3.4.
2. Press the "FUNCTION", "ORIGINAL SIZE (LEDGER/A3)" and "3" keys simultaneously in that order
to enter the Service Mode.
3. Enter the Copy Service Mode F5-70 (PM cycle) and change to the desired value.
4. Press “FUNCTION” and “C (CLEAR)” keys simultaneously to exit the Service Mode.
3.5.2. “Call for P/M Fuser Web” (Default: 240K)
1. Perform the P/M (Preventive Maintenance). Refer to Section 3.3 and 3.4.
2. Press the "FUNCTION", "ORIGINAL SIZE (LEDGER/A3)" and "3" keys simultaneously in that order
to enter the Service Mode.
3. Enter the Copy Service Mode F5-73 (Fuser web) PM cycle and change to the desired value.
4. Press “FUNCTION” and “C (CLEAR)” keys simultaneously to exit the Service Mode.
3.5.3. “Call for P/M ADF” (Default: Not shown)
1. Perform the P/M (Preventive Maintenance). Refer to Section 3.3 and 3.4.
Sheet Bypass
54 Paper Feed Roller 4608 120K
Water
1
240K
Refer to
Sect 2.2.14.
F7-03
Sheet
Bypass
Count
55
Feed Roller 4612 120K
Water
1
240K
56 Pickup Roller 4603, 4611 120K
Water
1
240K
Paper Exit Transportation
57 Exit Roller 2 8120 120K
Water
1
- Refer to
Sect 2.2.15.
F7-02
Total Count
58 Exit Roller 3 8312 120K
Water
1
-
3000-Sheet Large Capacity Tray
59 Paper Feed Roller 9111 120K
Water
1
240K Refer to
Sect 2.2.19.
F7-03
LCT Tray
Count
60 Feed Roller 9129 120K
Water
1
240K
61 Pickup Roller 9107 120K
Water
1
240K
No.
Mechanical Parts Ref. No.
Cleaning Replacement/Adjustment
Ref.
Counter
Cycle
(Sheet)
Method
Cycle
(Sheet)
Procedure