411
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
8.32. Installing the Power Supply for Finisher (DA-PW600)
8.32.1. Contents
Note:
1. The part number may differ depending on the Destination.
2. Refer to the Parts List in the Parts Manual.
8.32.2. Installation
CAUTION!
Turn the Power Switch on the Left Side and the Main Power Switch on the Back of the
machine to the OFF position, and then unplug the AC Power Cord before beginning
installation.
Qty. Description Part No. Remarks
1 Power Supply for Finisher See Note
1 LVSC Harness DZFP001286
1 Screw XTB3+6F
1 Installation Instructions DZSM000561 This document
(1) Open the Front Cover.
(2) Swing the Hopper Unit to the right side.
(3) Pull out 1st Paper Tray.
(4) Remove 2 Screws.
(5) Remove the LVPS Cover.
(6) Remove the LVCS Harness.
(3)
(5)
(4)
(6)
To Next Page
Loading...
