Panasonic DP-3510

176
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
4.5. Error Codes (For Copier)
The self-diagnostic functions detect troubles in the important components of the copier.
When any trouble occurs, the copier stops.
4.5.1. User Error Codes (U Code)
Note:
Uxx and a message will appear on the Panel Display.
User Error Codes (U Code) Table
Code Item Check Points
U0 Key Counter 1. Card Key is not installed.
2. Key Counter Harness is disconnected.
3. Department Code is not assigned.
U1 Close Front Cover 1. Front Cover is open.
2. Front Cover Sensor is disconnected.
3. Front Cover Sensor is defective
4. LVPS connector is disconnected.
5. LVPS is defective.
6. SPC PCB connector is disconnected.
7. SPC PCB is defective.
U4 Close Finisher 1. Finisher is open.
2. Paper is in the output bin.
3. Stapler is empty.
4. LVPS connector is disconnected.
5. LVPS is defective.
6. SPC PCB connector is disconnected.
7. SPC PCB is defective.
U6 Close Right Cover 1. Right Cover is open.
2. Right Cover Sensor is disconnected.
3. Right Cover Sensor is defective.
4. LVPS connector is disconnected.
5. LVPS is defective.
6. SPC PCB connector is disconnected.
7. SPC PCB is defective.
U7 Close Right Cover Lower
(System Console)
1. Right Cover is open.
2. Right Cover Sensor is disconnected.
3. Right Cover Sensor is defective.
4. LVPS connector is disconnected.
5. LVPS is defective.
6. SPC PCB connector is disconnected.
7. SPC PCB is defective.
U9 Close Left Cover 1. Left Cover is open.
2. Left Cover Sensor is disconnected.
3. Left Cover Sensor is defective.
U12 Close Finisher Staple Cover
/ Upper Cover
1. Close Finisher Staple Cover.
2. Finisher Staple Cover Sensor is disconnected.
3. Finisher Staple Cover Sensor is defective.
U13 Add Toner 1. Toner Bottle is incorrectly installed.
2. Low Toner.
3. Toner Sensor is disconnected.
4. Toner Sensor is defective.
5. SPC PCB connector is disconnected.
6. SPC PCB is defective.