Panasonic DP-3510

395
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
2. Unpacking
Note:
This finisher is protected with packing materials
such as tapes and spacers against vibration and
shocks caused during transportation. Be sure to
remove them before using the finisher.
Caution:
The finisher weights approximately 60 lb (27 kg).
To prevent injuries, use the appropriate number of
personnel and the proper equipment to lift or move
the finisher.
Move the finisher next to the left side of the
machine and remove the packing materials using
the following procedure.
(1) Take the Stapler, Finisher, and accessories out of
the package.
(2) Remove the tapes securing the Stapler, Finisher,
Accessory Cover, etc. along with the packing
materials.
Note:
The removed tapes and packing materials will be
needed when transporting the finisher for
relocation or repair; it is a good idea to store them
away for future use.
3. Preparing the Host Machine for Finisher
Installation
(1) Loosen the 2 Screws and remove the SPC
Cover.
(2) Remove the Toner Waste Container.
(Refer to Section 2.2.2. in the Service Manual)
(3) Install the Finisher IPC PC Board onto the SPC
PC Board, connector CN727.
(4) Reinstall the SPC Cover and the Toner Waste
Container.
Note:
Gently and securely insert the IPC PC Board as
illustrated.
(1)
(3)