Panasonic DP-3510

236
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
F9 Unit
Maintenance
06 RAM
Initialize
00 Parameter Initialize Resets the Fax and Function
parameters to default values.
Note: Turn the Power Switch on the Left
Side of the machine to the OFF and
back to the ON position to
enable the parameter settings.
01 All Job Clear Clears all Jobs stored in Flash Memory.
02 Not Used
03 Shipment Set Clears All Jobs, All Preset Data,
Parameter Initialize & Resets the
Counters (Fax).
04 LBP Fuser Reset Clears the LBP fuser error.
05 Dept. Counter Clear
07 Firmware
Update
00 Update from master
card
Updates the firmware in the machine
with the Master Firmware Card.
01 Update from parallel
port
Updates the firmware in the machine
with the Parallel Port.
08 Program
Backup
(Refer to
Sect. 3.6.)
00 Main Onboard F-ROM 4MB
01 Option 1 all Slot 1 FRM8 PCB 8MB
02 Option 1 a Slot 1 FRM8 PCB 4MB (a)
03 Option 1 b Slot 1 FRM8 PCB 4MB (b)
04 Option 2 all Slot 2 FRM8 PCB 8MB
05 Option 2 a Slot 2 FRM8 PCB 4MB (a)
06 Option 2 b Slot 2 FRM8 PCB 4MB (b)
09 Update Program Card Creates a Master Firmware Card using
the Firmware Update Kit. A 4MB or 8MB
Flash Memory Card will be required
depending upon the model.
10 Program
Copy
00 From card to slot 1 Configuration for Program copy.
01 From card to slot 2
02 From slot 1 to card
03 From slot 1 to slot 2
04 From slot 2 to card
05 From slot 2 to slot 1
11 Parameter Backup Backup the Parameter.
12 Parameter Restore Restore the Parameter.
13 Page Memory Size Displays the page memory size (MB).
14 Sort Memory Size Displays the sort memory size (MB).
F9 Mode
Service
Mode
Item Remarks