Panasonic DP-3510 - Page 245

245
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
Note 1: Continuous Polling (Station Mode)
This feature allows you to store or add documents into a polled file in memory.
To enable the Continuous Polling feature set Function Parameter No. 003 to "2:Station". The last
Program Key will be assigned with the "Store 4 Poll" Key name automatically and cannot be
changed.
To prepare the document(s) to be polled, simply place the document(s) on the ADF or Platen and
then press the Program Key to store or add the document(s) into a polled file.
(Note: If a regular polled file is stored in memory, the Program Key for Continuous Polling will not
be accepted.)
Note 2: Function Parameter No. 070 (Line Error)-Transmit condition of RTP/PIP or RTN/PIN
Note 3: Function Parameter No. 071 (Total Error)-Transmit condition of RTP/PIP or RTN/PIN
Note 4: The default setting of parameters depends on the country’s specifications or regulations.
Print the Function Parameter List to confirm the default settings.
116 OVERWRITE
WARNING
1 = Yes
2 = No
Selects whether the Overwrite Warning is included
on the Internet FAX Result Receipt when
programming the Auto Dialer via email.
117
~
121
Not Used
122 LDAP 1 = Off
2 = On
When LDAP is used, specialize characters may be
displayed as different characters.
Available from May production.
123
~
174
Not Used
175 FAX/EMAIL
Default
0 = Address Book
1 = Mode Set
Selects the FAX/EMAIL Default.
176
~
199
Not Used
Signal
Setting
1:128 2:256 3:512 4:1024 5:2048 6:Off
MCF/PIP 0-31 0-63 0-127 0-255 0-511 Always
RTP/PIP 32-63 64-127 128-255 256-511 512-1023 -
RTN/PIN 64-127 128-255 256-511 512-1023 1024-2047 -
Signal
Setting
1:5% 2:10% 3:15% 4:20%
MCF/PIP 0-2 0-4 0-7 0-9
RTP/PIP 3-4 5-9 8-14 10-19
RTN/PIN 5- 10- 15- 20-
Function Parameter Table
No. Parameter Selections Function