Panasonic DP-3510

288
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
(22) Shake a new Toner Bottle 10 to 15 times to
loosen the contents.
(23) Remove the Cap from the Toner Bottle.
(24) Insert the Toner Bottle into the Hopper Unit. Align
the Key of the Toner Bottle with the Key
Alignment Channel of the hopper unit. Insert the
Bottle as far as it will go and turn the Toner Bottle
clockwise until it locks in place. (Arrows on the
Bottle and the Hopper are aligned)
(25) Swing the Toner Bottle / Hopper closed (180°).
(26) Close the Front Cover.
(27) Plug the AC Power Cord into the wall outlet and
turn the Main Power Switch on the Back and the
Power Switch on the Left Side of the machine to
the ON position.
Note:
Perform the following adjustments after the
machine has warmed up and displays:
<For Other Destinations (not USA and Canada),
follow the steps (28) ~ (34) below>
(28) Install the Exit Tray Assembly to the Upper Exit
Cover.
(29) Open the Upper Exit Cover.
(30) Remove 1 Screw to free the Upper Exit Cover
Stopper.
(31) Install the Stop Plate and secure it with 1 Screw
as illustrated.
(32) Install the Stop Plate 2 and secure it with
1 Screw as illustrated.
(33) Secure the Upper Exit Cover Stopper with 1
Screw (removed in step (29) above).
(34) Close the Upper Exit Cover.
Toner Bottle
Hopper
Ready To Copy
Set Originals
(29)
(33)
(31)
(32)