Panasonic DP-3510

344
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
(4) Pull out the 3rd Tray Rear.
(5) Secure with 2 Large Screws attached in the
System Console as illustrated.
<Replace Gear for Adjusting the Speed>
The factory setting is for DP-3530 / 4530.
If you are installing onto DP-6030, adjust the speed
by following the steps below.
(1) Remove 2 Silver Screws.
(2) Remove the Lower Rear Cover.
(3) Remove 2 Snap-Rings.
(4) Remove the Belt, 2 Gears and 2 Plastic
Washers.
(5) Turn both Gears over and reinstall 2 Gears,
2 Plastic Washers and the Belt.
Note:
When reinstalling the gears, mount the Plastic
Washers onto the gears first before inserting them
into the shaft.
(6) Make sure the Gear Combination to Match the
Speed.
(7) Reinstall the Lower Rear Cover.
(4)
(5)
(1)
(2)
(3)
DP-6030: 6 Ribs outside
(Plastic Washers)