Panasonic DP-3510

351
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
8.23.3. Side-to-Side Adjustment of the LSU Image
1. Press the "FUNCTION”, “ORIGINAL SIZE (LEDGER/A3)" and “3” keys simultaneously in that order to
enter the Service Mode.
2. Press the “6” key to enter the F6 Mode.
3. Press the “START” key.
4. Press the “1”, “5” and "START" keys sequentially to enter the F6 Mode code “15” for the Side-to-Side
adjustment of the LCT (-8 to 7).
5. Press the “STOP” key.
6. Press the “FUNCTION” and “C” (CLEAR) keys simultaneously to exit the Service Mode.
7. Make a copy to verify your adjustment, repeat the steps above if further adjustment is required.
(10) Connect the LCT Cable to the machine.
(11) Connect the System Console Cable to the LCT.
(12) Install the Harness Clamp (PLWS4) on the Rear
Cover.
(13) Secure the System Console Cable with the
Harness Clamp.
(14) Plug the AC Power Cord into the wall outlet and
turn the Main Power Switch on the Back and the
Power Switch on the Left Side of the machine to
the ON position.
(15) Make a copy and verify that the Image is
centered. If the Image is not centered, proceed
to step (16) and perform the Side to Side
adjustment.
(16) Loosen 2 screws and adjust the Rail Assembly
to the front and rear accordingly as
illustrated.
When finished, verify the image and repeat the
adjustment if necessary.
(11)
(13) (14)
(12)
(16)
(16)