Panasonic DP-3510

365
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
(11) Remove 2 Screws.
(12) Remove the Exit Roller E Assembly.
(13) Secure the Exit Roller U Assembly with 2
Screws.
(14) Reinstall the Exit Guide 1 Assembly and Exit
Guide 3 Assembly.
(15) Close the Upper Exit Cover.
(16) Insert the bottom 2 Silver Screws (M4 x 12) first
and tighten them 1/2 way.
(17) Place the Latch Plate on top of these Silver
Screws (M4 x 12).
(18) Install the upper 2 Silver Screws (M4 x 12), and
then tighten all the 4 screws.
Note:
If the Punch Unit (DA-SP31) is also being
installed, before continuing to the next step, install
the Punch Unit (DA-SP31) first.
(19) Install the Inlet Guide.
(20) Secure it with 2 Silver Screws (M3 x 10).
(11)
(12)
(11)
(13)
(13)
(16)
(18)
(16)
(17)
(18)
(20)
(19)
(20)