Panasonic DP-3510

367
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
5. Connecting to the Host Machine
(1) Bring the Finisher closer to its Host Machine so
that the Pickup Assembly of the Finisher and the
Delivery Assembly of the Host Machine match in
height; then, connect the two with care.
If the connection is correct, the Guide Pin of the
Latch Plate will fit, and there will be no gap
between the two. If there is a gap either at the
front or the rear, adjust the height position of the
Finisher.
Caution:
Be sure to install both Finisher and the Host
Machine on a flat floor surface. A difference in
height can lead to faulty movement of paper.
(2) As illustrated, install the Face Plate Button in the
round hole of the Right Guide Assembly of the
Finisher. However, do NOT install it if you are
also installing the Punch Unit.
(3) Install the Connecting Plate.
(4) Install these 2 Screws (M4 x 8) first.
(5) Install these remaining 2 Screws (M4 x 8).
Note:
Make sure that the Guide Rail is kept horizontally
on the Floor.
(6) Connect the Finisher and its Host Machine with
the Interface Cable.
Face Plate Button
(3)
(4)
(5)
(5)
(6)