386
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
(4) Securely connect one end of the Punch Relay
Harness to J3 and J4 of the Punch Driver PC
Board.
Note:
Loose connections can result in malfunction. If the
Punch Unit malfunctions after installation, try
disconnecting and then re-connecting the
Connector.
(5) Hook the Punch Unit on the Mounting Screw
which was installed in step (2).
(6) Secure the Punch Unit to the Finisher in place
using Shoulder Screws as illustrated.
(7) Secure the Punch Lower Cover to the Finisher
as illustrated with 1 Silver Screw (M4 x 12) at the
top and 1 Black Screw (M4 x 6) at the bottom.
Punch Relay Harness
Punch Driver PCB
J3
J4
Shoulder Screws
(7) Silver M4 x 12
Punch Lower
Cover
(7) Black M4 x 6
To Next Page
Loading...
