392
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
(5) Hook the Bosses of the Finisher to the Rails as
illustrated and secure the Finisher with 2 Screws
(one on each side) (M4 x 8).
(6) Install the Front and Rear Covers as illustrated.
(7) Secure the Covers with 2 Screws (M4 x 10).
(8) Install the Upper and Lower Trays.
(9) Install the Locking Clamp.
(10) Place the Interface Cable into the Locking Clamp
and connect it to the Host Machine.
(11) Slide the Finisher towards the Host Machine.
Note:
Ensure that the Magnet Catch Plates are aligned
with the Magnets of the Finisher.
Finisher
(6)
(7)
(7)
(6)
Lower Tray
Upper Tray
Finisher
(9)
(11)
(10)
To Next Page
Loading...
