414
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
Note:
After the Key Counter installation, ensure that the harness and the connector are not exposed.
(8) Secure the KCTU Harness to the 4 Harness
Clamps.
(9) Connect the KCTU Harness to CN765 on the
DRV PC Board.
(10) Remove the Protective Tab on the Right Rear
Cover.
(11) Reinstall the Right Rear Cover and Upper Rear
Cover.
(12) Plug the AC Power Cord into the wall outlet and
turn the Main Power Switch on the Back and the
Power Switch on the Left Side of the machine to
the ON position.
Note:
As a safety measure, if the Key Counter is not being
installed, cover up the aperture with the Connector
Cover and secure it with 2 Screws.
(9)
(10)
To Next Page
Loading...
