502
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
11.1.2.1.1. Outline
The Finisher is designed to deliver copies arriving from its Copier, and its modes of delivery include simple
stacking, job offset*
1
, and staple.
All operations involved in these modes are controlled by the Finisher Controller PCB, according to the
appropriate commands from the Copier.
Copies from the Copier may be routed to the Saddle Stitch Unit.
Fig. 2-001
Notes:
*1:The term job offset refers to shifting each sorting job, separating a single stack into several stacks.
Control system
Swing guide drive system
Alignment drive system
Stapler drive system
Delivery drive system
Feeder drive system
Shutter drive system
Tray drive system
Saddle stitch unit control system
To Next Page
Loading...
