Panasonic DP-3510

525
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
Fig. 2-037
4. Last sheet
When the last sheet has been put in order, the Finisher Controller PCB turns on the Alignment Motor
(M3) to move the Alignment Plate to the alignment position (to butt the plate against the stack). Then,
the Finisher Controller PCB rotates the Swing Motor (M7) counter-clockwise to move down the Swing
Guide.
The Finisher Controller PCB moves the stapler according to the staple mode for stapling. From then
on, it rotates the Delivery Motor (M2) clockwise to delivery the stack to the tray.
Fig. 2-038
M8
Stapler
1st Sheet
2nd and Subsequent
Sheets
Paddles
Paddles
Paddle
Solenoid (SL5)
Stopper
2nd Feed Motor
Delivery
Roller
Swing Guide
Sheets
Stapling Tray
Tray 1/2
Feed Belts
Feed Roller 2
Stapler