69
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
Note:
When reinstalling the Cleaning Blade Assembly,
make sure that the Hooks are properly attached.
(23) Release 4 Latch Hooks and remove the Front
and Rear Cleaning Felt (1849, 1848)
Assemblies.
<Cleaning the Density Sensor>
(24) Clean the Density Sensor (CDS PC Board)
(1846) with a dry cloth.
(25) Remove 1 Screw (L9).
(26) Turn the Corona Unit upside down.
(27) Push-in the Grid Base (1910) to unlatch and
remove the Corona Grid (1919).
To Next Page
Loading...
