Panasonic DP-3510

712
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
11.2.5. Section V Troubleshooting
11.2.5.1. Error Detection by Self-Diagnostics
The self-diagnostics function detects troubles in important areas of the Finisher. When any trouble occurs,
the Machine stops. The error indication appears in the “message” display of the Copier and the “Alarm”
indicator on the copier turns ON.
1. User Error
2. Paper Jam
Code Problem Cause/Check
U4 Finisher Inverting Unit/Inverting Shift Tray
(Option)
1) Are the exit options installed correctly?
2) Exit option connector(s) is shorted or loose.
3) Exit option connector(s) is defective.
4) Finisher CPU PCB connector is shorted or
loose.
5) Finisher CPU PCB is defective.
6) LVPS connector is shorted or loose.
7) LVPS is defective.
8) CPU PCB connector (CN15) is shorted or
loose.
9) CPU PCB is defective.
oF Finisher Tray Capacity Copies exceeded the maximum capacity of
the finisher tray. Remove the copies from the
finisher’s tray and press the Start key. (Face
Down only)
Code Contents
J60 When the finisher is installed.
a) The finisher entry paper feed sensor does not detect paper within a predetermined time
after the copier paper exit sensor detected paper.
b) The finisher entry paper feed sensor does not turn off within a predetermined time.
c) The finisher paper exit sensor does not detect paper within a predetermined time after the
finisher entry paper feed sensor detected paper.
d) The finisher paper exit sensor (straight) does not turn off within a predetermined time.
e) The finisher paper exit sensor (invert) does not turn off within a predetermined time.
J62 The Paper is Jammed in the Inverter.
The Paper Exit Sensor (Inverting) (PC3) detects paper jam in the Inverter or/and paper exit.