735
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
11.3.2.2.2. Feed / Delivery
1. Outline
The Machine forwards the sheets coming from its host machine to the Delivery Tray, Processing Tray,
or Saddle Unit according to the type of delivery used. The sheets forwarded to the processing tray or
the Saddle Unit are offset, stapled, or folded.
Fig. 2-015 shows the motors that are associated with moving and aligning sheets. These motors are
controlled (rotated clockwise or counter-clockwise) by the microprocessor (CPU) on the Finisher
Controller PCB.
The paper path is equipped with the sensors shown in Table 2-002 used to monitor the arrival or
passage of sheets.
If a sheet fails to arrive at or move past a specific sensor within a specific period of time, the Finisher
Controller will assume a jam, and stops the ongoing operation and, at the same time, communicates
the presence of a jam to the Host Machine.
Table 2-001
Notation Name Description
Connector on Finisher
Controller PCB
M1 Paddle Motor Stepping Motor CN10
M2 Feed Motor Stepping Motor CN10
M3 Delivery Motor Stepping Motor CN13
M4 Alignment Plate Motor (Front) Stepping Motor CN3
M5 Alignment Plate Motor (Rear) Stepping Motor CN3
M7 Staple / Fold Motor Brush DC Motor CN6
To Next Page
Loading...
