Panasonic DP-3510

738
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
11.3.2.2.3. Job Offset
1. Outline
"Job offset" refers to the operation by which the machine delivers a set of sheets with them pulled
forward or backward for sorting.
Switching between the forward and backward directions is accomplished by using an aligning plate
(Front) and an aligning plate (Rear).
The sheet coming between the Delivery Rollers is fed onto the Processing Tray and then fed toward
the stopper by the Paddle.
A swing guide is at the upper position while a sheet is being pulled onto the Processing Tray or during
alignment. It is at the lower position during stack feeding, stack delivery, or stapling.
At power-on, the Finisher Controller PCB drives the Aligning Plate (Front) Motor (M4) and the Aligning
Plate (Rear) Motor (M5) to return the two aligning plates to their home positions.
Table 2-003
Fig. 2-017
Sensor Symbol Connector Function Motor Symbol
Aligning Plate (Front)
Home Position Sensor
PI4 CN4-3 Drives the Aligning Plate
(Front)
Aligning Plate
(Front) Motor
M4
Aligning Plate (Rear)
Home Position Sensor
PI5 CN5-15 Drives the Aligning Plate
(Rear)
Aligning Plate
(Rear) Motor
M5
Swing Guide Home
Position Sensor
PI3 CN9-9 Drives the Swing Guide
Drive
Paddle Motor M2
Paddle Home Position
Sensor
PI2 CN9-3 Drives the Paddle (feeds
paper)
Paddle Motor M2
A
ligning Plate
(
Front)
Light-Shielding Plate
Alignment Plate (Front)
Motor (M4)
Aligning plate (Rear)
motor (M5)
Aligning plate (Rear)
Paper
Aligning Plate (Front) Home Position Sensor (PI4)
(Front)
Aligning plate (Rear)
home position sensor (PI
5)
Light-shielding plate